Text Box: First Prototype Assembly Text Box: Silicone Rubber Molds for Housing Half (first cast part) Text Box: SLA Rapid Prototype Housing Text Box: Cross-section of design Text Box: 3D CAD Design (ProE) Text Box: AeroCam In-Car Video Text Box: Alternative Rooftop Mounting Text Box: AeroCam In-Car Video; This was a product idea I came up with as a Driver training aid. When you are an amateur racer you never get enough track time/practice. Being able to review your on track session helps fill that void, especially with Data Acquisition overlaid. The design utilized an OEM CCD imager board, which was mounted between the (2) halves of the housing. Also mounted inside the housing was a microphone. The whole assemble had multiple mounting configurations which used a special vibration dampening material; Sorbathane The Housing was assembled using thread forming screws. A single shielded cable connected to a remote recording device. The Prototype was created by having a SLA made from the ProE CAD file, from that I made a Silicone Rubber mold for the (2) Housing halves, Rollbar "V" mount and CCD Mounting Nest Blocks. The inner Clamp Plate was made from Sheet Aluminum with PEMs and the lower Mounting Plate machined from Aluminum Plate. I made a steel rule die to make the Sorbathane Isolation Pad. (view  video from prototype below) Text Box: Racing Products Text Box: Vincent T. LaManna’s Resume/Portfolio

Back Next